Join Date: Nov 2010
Location: Central Coast, CA
moving shift lever
I'll chime in...I did this on my 11 XC...after moving the shift lever to the forward position, the rod would not reach unless the lever was laying almost on the floor board. I released the pinch bolt on the shifter arm where it attaches at the case. pulled it straight off, then indexed it 2 or 3 teeth clockwise. the rod can then be re-attached. Have no problems with this configuration so far. Hope this will work for you...just dont forget to tighten down the pinch bolt on the shift arm and the lock nuts on the rod. I used locktite on all bolts to ensure no loosening I didnt want!
MSgt Ret. Security Forces USAF/Lompoc, CA
2011 Victory Cross Country (Imperial Blue)
-Mods-Vic Military Salute Wedge Covers/Vic Passenger Backrest/Vic Flip shield/Floor Board Hwy Pegs/2012 Hard Lowers/Hard Bag Bars/adj. pass. foot rests/+2 SRVT Pull Back Bars/Mirror extenders/Kuryakyn little silver bullet driving lights/WOLO horn/RicZ laid down plate bracket/Kuryakyn Brake Pedal/Signal Dynamics headlight modulator/Custom Dynamics Brake light Strobe/1/4 turn throttle ring/Lloydz timing wheel +4