Picked up a V92C and needed a few pointers on what I might be able to do to get it started.
It's been siting about 5yrs. I cleaned the old gas out, new plugs, put new gas in and checked for spark and it has spark but still won't fire... Thanks for any help...Turns over strong and I'm hearing the fuel pump cycle.
Carl-

Carl I'm sure KevinX will chime in tomorrow and get you going. He is considered by many to be THE Victory Tech. He's down in Florida and chimes in here every weekday.

Just because you hear the pump cycle; does not mean it is working. You need to check fuel pressure. Spec is 49psi

Will do...I will give it a try today.
Thanks guys...

Well I cycled the key a couple of times and the shreader valve did not seem to have any pressure so i pulled the guts out of the valve and cycled it to see I had anything, and only had a few drips.
Pump is not humming at all and seemed to be a little warm after quite a few times of cycling.
What would be the best way to replace the pump?

Don't really understand your question. If you are talking about HOW to change it. You need to pull the rear schock for access.

Sorry. Yes I was talking about changing the fuel pump.
Thanks....

Check your prefilters. Drain the tank, then remove the fuel lines from the rear of the tank.. The prefilters are in the metal tubes.
There was a recall on the fuel pump, replaced by dealer at no charge.