Hello, I can't seem to find the size of the rear axle nut in the manual. I assume that it's metric but not sure and I want to go buy a socket for it. Can someone tell me what size the nut is for the rear axle nut? 2012 Cross countryThanks,LongRIder
If you plan on torqueing it down then you will need the 27mm crowsfoot and adjust your lb's for the extra length. It is 57 lbs for my torque wrench and crows foot (the being if my torque wrench is still accurate).
I do plan on torquing the nut to the proper setting. If I buy the crowsfoot, is there a formular to figure out what to set the wrench at to get to the 65 ft lbs? Also, does anyone if a fastener listing is available for these bikes? I noticed that the manual does not do a good job of identifyting fastener sizes.
thanks,
LongRIder
The question is, will a torque wrench still measure accurately if a cheater bar is used on the end? The answer is yes. All this configuration will do is increase the force on the end of the torque wrench. The torque measured by the wrench doesn't care if there is a hand pressing down on the wrench or if a cheater-bar is supplying the force.
No problem. If you are adjusting your belt just a warning that when you torque the bolt down it will probably affect the position of the belt on the sprocket. I ended up getting the belt all the way to the left side then a few runs of torque down nut and spin tire then lossen bolt and mess with adjuster nut till I got the belt where it would not run on one side of the sprocket.
Just a note about calculating tq variances when using any sort of extended leverage (such as with a crows foot) on a torque wrench. If you turn the foot 90 degrees to the handle, so that the total leverage length from the end of the handle to the nut is the same as if it were centered on the ratchet, then the torque value remains at 65 lb/ft. It's not the length of the crows foot that matters, it's the total leverage distance..... so, at 90 degrees, the distance is unchanged, and no calculation is required.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Victory Motorcycle Forum
497.1K posts
48.6K members
Since 2007
A forum community dedicated to Victory Motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!