12" Ness Modular drag bars on Vegas

[jaysonL]

these pics were on the facebook page of LA Choppers. They are making and perhaps have these club bars now for Victory's. Here are a couple crappy shots of them on a Vegas....

[HoodsBackVegas]

I know funny question but cant resist, Does anyone know the size of Socket i will need to take my risers off ?? Only reason I ask is because I need to take tools home from work today..

[gibson]

2013-01-02 08.41.26.jpgunder the riser is metric nut, clamps for handle bars is metric Allen, My bike is buried in the garage because of the weather . Looking at the display in the manual.. so I would bring home sockets to take the risers off

[HoodsBackVegas]

yea same picture im looking at.. I downloaded the manual from thread.. Just didnt know if someone knew off hand that has changed them didnt want to bring home more then i needed but looks like I might have too..Unless someone answers before i leave... Thanks again Gibson for all your input sir..

[HoodsBackVegas]

Well project is well under way, went home yesterday with some tools from work and a couple beers to calm the nerves... To answer our question from previous days, Riser nuts are a 19mm also all the pins can come out of the hardshells...A little note taking and picture popping they come out pretty easy..Not going to lie took me a minute to figure out the first pi,once i did it was on from there..total disassembly of stock bars half hour..But pin popping, wire running and some minor mods plus taking time to make sure to tripple check every thing about 3 hrs... Some tedious work but finish product looks amazing will mount on bike later today..I have pictures up to this point just need to figure out how to post them..Again thanks to Gibson for his input..

[gibson]

Originally Posted by HoodsBackVegas

Well project is well under way, went home yesterday with some tools from work and a couple beers to calm the nerves... To answer our question from previous days, Riser nuts are a 19mm also all the pins can come out of the hardshells...A little note taking and picture popping they come out pretty easy..Not going to lie took me a minute to figure out the first pi,once i did it was on from there..total disassembly of stock bars half hour..But pin popping, wire running and some minor mods plus taking time to make sure to tripple check every thing about 3 hrs... Some tedious work but finish product looks amazing will mount on bike later today..I have pictures up to this point just need to figure out how to post them..Again thanks to Gibson for his input..

Copy photos to your desktop, in thread go advanced, click on the paper clip(attachments), click on browse, find the photo on your desktop,upload, back to your paper clipelec.jpg, click on the photo you uploaded. It now should appear in your thread..This is a Electrician joke..

[HoodsBackVegas]

1.jpg

2.jpg

3.jpg

4.jpg

5.jpg

[HoodsBackVegas]

6.jpg

7.jpg

8.jpg

9.jpg

[jaysonL]

Very cool.....looking good !

[gibson]

Good job, you s a old pro now..