I want to add an Aux Battery terminal somewhere near the seat to use for connecting rider and passenger heated gear. I don't want to have to disassemble much of the bike to do it. Does anyone know of an easy way to route the wiring so it's out of the way and does not intefere with any routine maintenance procedures?
If you have done this, What product did you buy for the accessory terminal. I am also thinking of mounting the heating controllers on the bike. Any thoughts.
Well a couple ideas but could use a bit of info what you got on the bike.
If no heated seat I think you will find a 2pin connector Blk / Blu-Pink which is the wiring for the heated seat option. I am unsure if it is already run or not.
If no connector, look for blu/pink wire heading to the trunk. that is your accesory for the trun which is a 20amp. Keep in mind that is fused to the windshield.
Both of these are switched so ignition off will secure power to any gear left plugged in.
Im guessing two jackets, I know my jacket is 6amp max draw. I like Johnny's stash points for the cables, if your going to run wiring I would make a fused harness running post solenoid and heat shrink then just zip tie in with current harness front and back.
Just some thoughts, if you have not downloaded the 09 service manual, go to tech section and search BBob and service manual. He has it up for download and you can go from there.
2011 White Vision - Nuvi 550, Lowers, Lloydz 2nd filter, Vic perf filter, CB/Icom, 96 Brake LED's, Clear Signal lens/Switchbacks, VIC Hwy Pegs, Stebel Horn, 7Jurock 15" Shield, PCV, Lloyd ATS and Variable intake, Ness honkers
2004 V92 TC - S1 flash, level 1 slip-on, Ness big sucker K&N, ISO Grips, 4x1.5 Highway Hawg Risers, extra chrome (never too much), JM 2k CB 4' antena, Mustang seat, HD Front TS & Lowers, OD Pulley
Retired Navy SCPO