I pulled the primary cover to replace my clutch. Clutch engages and disengages fine and bike runs well in 1st gear. My problem is that the shift shaft pulls out of the case too much and I can not shift. If I push on the shaft inward it shifts as it should. I think its probaly the retaining ring on the shift shaft being bent but wanted some opinions.
New .40 cent e clip solved the problem. Apparently I messed the old one up when installing the primary cover.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Victory Motorcycle Forum
497.1K posts
48.6K members
Since 2007
A forum community dedicated to Victory Motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!