I think I found a nice solution for Bluetooth and amp upgrade. https://www.amazon.com/gp/aw/d/B00UT...236_SY340_QL65 I did a lot of research on it, seems solid. I just ordered mine today, so once it's here I'll do a write up on it. (Will be my first write up so be gentle).
I ordered the vtwin mount for it (even tho the amp will fit on the smaller one for the RF amps). So it will be under the fairing and then I'm gonna remove the factory handle bar controls and mount the new kenwood one there. I'm worried cuz I have 2ohm infinity speakers so I'll only be at 45w rms x 2. I plan on switching to 6.5 components @ 4ohms so I can run 90w rms x 2.
2002 HD Sportster 1200 Custom -sold
2013 XCT Boardwalk Blue picked up 1/21/2014
Vance and Hines hi output slip-ons
Lloydz hi-flow air filter
Lloydz ATS @ +4
CrossRoads HID's Hi and Low
So today I installed the amp. Took a couple hours, but overall wasn't hard. So far I love the amp, the only downfall is you are limited to your EQ on your phone or media device, unless you download some sort of EQ app.
Running the wires to the battery was a piece of cake, just picked up some wire loom to keep it clean. Also added a 20a in line fuse. The mount I used was from vtwin. (Shipping was quick and mount was flawless) ImageUploadedByMO Free1466391922.592361.jpg
Overall the amp even wired at 45w rms sounds great. Damn loud also. I only rode for about 30 min today, but it synced right up and switching tracks was flawless. I would definitely recommend this amp. 👍