||LinkBack||Thread Tools||Search this Thread||Display Modes|
Rotating clutch/brake levers
Is it possible to rotate the clutch/brake levers on the handlebars so that they are more horizontal? I feel like I have to reach down from the grips to get to them.
Join Date: Jan 2014
Location: Havelock, NC
You certainly can, just loosen the Allen screws that hold the brake and clutch clip in place and rotate. On the clutch side be careful about location with respect to mode switch for trip computer. I would have not noticed it but read in a forum last night from another member. If you cannot rotate, then you need to clip off the alignment tab from the back where it goes into alignment hole on handlebars. It is for the factory to ease in installation and uniformity.
Master Sergeant, USMC Retired
2002 HD Sportster 1200 Custom -sold
2013 XCT Boardwalk Blue picked up 1/21/2014
Vance and Hines hi output slip-ons
Lloydz hi-flow air filter
Lloydz ATS @ +4
CrossRoads HID's Hi and Low
I drilled another hole into my HMD bars to relocate for my reach. I didn't want things to loosen up on the bars. The alignment hole does help to keep the controls locked in place.
2011 Cross Country. D&D's wrapped - VM1DR cams - PC5 - LLoyds high performance filter and ATS (Adjustable Timing system). Power output 115HP/115FTLBS tuned by KMC. Klock Werks flip shield - RF/PBR300x4 amp - Hertz HCX 6.5's - Victory 6X9 Magnum Lids - Victory XM - HMD Black Pull Backs with Victory performance grips. PIAA Led3 driving lights. accessories from Arlen ness - Witch Doctors - Noemtz Designs - Kuryakyn. Blacked out treatment powder Coat by PPC Stuart fl.
|Thread Tools||Search this Thread|