1/4 throttle instalation need help
I am trying to install the 1/4 throttle ring on a 2014 xct and i am doing something wrong but i do not have enough cable to finish the instalation. I have watched witchdoctors' video and i compleated the following steps:
1.- I have lossen the nuts (left side of the bracket) of both cables at the throttle body to get some slack
2.- I have lossen the cable micro adjusters on the handlebar all the way to get the maximum cable slack
3.- I have opened the switch casing, installed the 1/4 ring (the grips are the heated stock ones)
4.- Connected the back cable over the ring, no problem
5.- Then tried to connect the front cable over the ring to it's housing and that is when my problems started, i do not have enough cable to drive it in its housing.
Please advise what i have done wrong or missing
2014 XCT, Utopia Backrest, Guard Dawg, Longhorn brake pedal, ISO Longhorn shifter, Arlen Ness gas cap, VM-1 Cams, Lloydz ATS, Lloydz air filter, PCV, Madstad Windshield, Victory HID, Vance & Hines Hi-output. 118/120 Dyno tuned by Kyle.