Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
946 Posts
Discussion Starter #1
Going to work this morning my abs light came on after it got light enough to see I visually checked it and couldn't see anything wrong any suggestions
Thanks it's on a 12 xr
 

·
Premium Member
Joined
·
6,235 Posts
Going to work this morning my abs light came on after it got light enough to see I visually checked it and couldn't see anything wrong any suggestions
Thanks it's on a 12 xr
There is a whole Thread about this, interesting stuff and ideas... But no luck for me, so i ordered new ones

Andre
TaPaTaLk
 

·
Premium Member
Joined
·
1,250 Posts
Going to work this morning my abs light came on after it got light enough to see I visually checked it and couldn't see anything wrong any suggestions
Thanks it's on a 12 xr

I think one of the most common issues is dirt on the sensor and/or the gap between the sensor and wheel. Check both. My gap was on the outside edge of the spec and it came on like that. I adjusted it and never saw the problem again.
 
  • Like
Reactions: visionjohnny

·
Premium Member
Joined
·
5,078 Posts
Friend of mine had that happen in his Vision, had a loose battery cable the light never came back on.
 
  • Like
Reactions: visionjohnny

·
Premium Member
Joined
·
1,608 Posts
9 out of 10 times, its a bad sensor.
 
1 - 6 of 6 Posts
Top