Victory Motorcycle Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
1,001 Posts
Discussion Starter #1 (Edited)
Here are my fuel tables, am trying to get autotune to dial things in, but running just terrible at about 2600-3000 rpm. Any knowledgeable suggestions Thanks!











 

·
Premium Member
Joined
·
1,001 Posts
Discussion Starter #2
Added trims and ignition tables
 

·
Premium Member
Joined
·
2,436 Posts
With what little experience I have on it, those number look way out of where they ought to be. Then again, I don't have a cam and a big bore. I'm thinking if your map is known to be good, zero out the fuel tables and trims. The AT will figure the rest out.
 

·
Registered
Joined
·
329 Posts
Replaced exhaust gaskets and zero'd out all my tables.

I then contacted DynoJet and they tuned it over the phone. Bike runs GREAT!

Now, I just need to get a better set of tires that will put the power down bettercheers
 

·
Premium Member
Joined
·
1,001 Posts
Discussion Starter #5
Turns out the AutoTune Module was bad, took it off as a suggestion by Rylan and walah, no problems! Sent it in for replacement.
 
1 - 5 of 5 Posts
Top