Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1 (Edited)
Just wondering if any one has broke off the heat shield clamps on the exhaust?? I broke my clamps for powder coating and want to know if I had enough clearance for a regular screw type hose clamps?
The factory clamps are a non-adjustable type clamp called "Band It"
I recently purchased a RPW exhaust and was given 6 Large hose clamps but the shields next to the engine is really close...
Any ideas would be greatly appreciated......
 

·
The Diamond
Joined
·
4,001 Posts
I've never worked on a Cross bike exhaust so I may be totaslly wrong but usually its just a matter of getting the correct angle for it tto go on.
 

·
Moderator
Joined
·
13,002 Posts
All the vision have hose claps holding there heat shields on.
All the after market world use hose clamps to hold there heat shields on.
 

·
Registered
Joined
·
35 Posts
I used 4" hose clamps to put mine back on when I recored my pipes. Works like a charm!
 
1 - 6 of 6 Posts
Top