Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Super Moderator
Joined
·
4,967 Posts
Discussion Starter #1
How do you take these apart if it's even possible. I want to Plasti Dip the backside like I did my Memphis Shades fork mounted wind deflectors but can't see how to break them down without breaking them.
 

Attachments

·
Moderator
Joined
·
13,003 Posts
not sure but if you want it shiny paint the back side
 

·
Premium Member
Joined
·
4,498 Posts
How do you take these apart if it's even possible. I want to Plasti Dip the backside like I did my Memphis Shades fork mounted wind deflectors but can't see how to break them down without breaking them.

I never took mine apart... I painted the front side with VHT nightshades. It didn't look that great so then I Plastdipped them... Didn't really like that either, so now they are sitting in drawer in my tool box. I only had flat black plasti dip though... I think glossier is the way to go here Vin.
 

·
Registered
Joined
·
156 Posts
I took mine apart, it looks like they are permanently assembled, but they are anything but.

The pins that hold them in place are basically in halves, really once you get them up close it will become obvious.

I tried to paint mine with tint but will now color match them.

The tint looked like crap, next is color match.


[/HTML]
 

·
Super Moderator
Joined
·
4,967 Posts
Discussion Starter #5
The plan is to paint the backside with Plasti Dip because it looks so good on the Memphis Shades fork deflectors. I'll take one off and mess with it, if it doesn't come apart easy I'll leave them as is.
 

·
Premium Member
Joined
·
9,684 Posts
Vin , the pins pop right out . I color matched mine too . Like Draper said , they are each in 2 pieces .
 
1 - 6 of 6 Posts
Top