Victory Motorcycle Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
170 Posts
Discussion Starter #1
Few weeks ago I rewired my entire bike from the ACM back. I rerouted the harness and did all the good stuff. Well, everything seemed to work fine except the right rear turn signal. Since I spent the better part of an entire weekend doing it, I decided I didn't care too much and I would live without it until I decided it was time to try again. On Friday I found me a little motorcycle repair shop in the Bx, one where they fix your bike right out there in the middle of the street. The guy came out, check a few wires and it would seem I was not getting a negative polarity from the ground wire so he grounded the signal light to the bolt that holds on the turn signals and success, right turn signal works. Now today I take the back of the bike apart to run some wire for the license plate bracket, put it back together and the right turn signal is GONE!!! I did everything he did, but still not signal. UGH...any suggestions?
 

·
Registered
Joined
·
427 Posts
Clean the ground contact.
 
1 - 2 of 2 Posts
Top