Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter #1
Ok, I looked for days to find the bars I wanted and ordered them. What I overlooked was the bars are for a Harley which uses a 1/2 bolt. My bike is a 10mm bolt. Without drilling out the triple clamps, what can I do or what have you done? Kirk has an adaptor mount kit but from what I can tell in the description its only 30mm long. My clamp is 40mm. I also don't want to return the bars. Someone here has had to have done this already?
 

·
Registered
Joined
·
88 Posts
Discussion Starter #3
I don't have risers. I ended up drilling the tripple clamp.
 

·
Registered
Joined
·
88 Posts
Discussion Starter #6
:worthless without:
I know, been busy. Lost a biker brother in a bike crash the next day, haven't got around to it yet. But anyways, very easy. Took the tripple clamp off in 5 minutes, no bearing to worry about on the Vic. Locked it on a drill press and drilled the holes to half inch. I do this with my phone mostly so haven't figured out pictures yet
 
1 - 6 of 6 Posts
Top