Victory Motorcycle Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter #1
Now that my broken ankle is almost allowing me to ride again, I should install this Witchdoctors heel shifter.

I don't see a video on the WD site....

Who's done this? What are the steps and gotchas?
 

·
Registered
Joined
·
107 Posts
Piece of cake. Undo the bolts holding the shifter pivot to the floorboard and undo the linkage at the engine end. Slide the shifter out of the floor board. A couple drops of threadlock blue, snug up the bolts and reinstall. I would have had to try to eff it up.
 

·
Registered
Joined
·
85 Posts
Discussion Starter #3
Thanks Edalfa.

Which way does the shifter slide, to the rear?

Probably tackling this tomorrow, stay close to your computer! ;)
 

·
Registered
Joined
·
216 Posts
I see that the heel shifter comes with 2 bolts yet I have no bolt holes on my shifter.....:confused:
 

·
Registered
Joined
·
4,091 Posts

·
Registered
Joined
·
216 Posts

·
Registered
Joined
·
131 Posts
You can purchase the one piece shifter, this one fits the 10 XC. [ame]http://www.amazon.com/Victory-Motorcycles-Chrome-Heel-Toe-Shifter/dp/B002Z352HQ[/ame]
 

·
Registered
Joined
·
216 Posts
1 - 11 of 11 Posts
Top