Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,071 Posts
Discussion Starter #1 (Edited)
3 cuts with a cutoff saw. a little hammer and dolly work.
epoxy primer and i now have a laydown bracket.
 

·
Registered
Joined
·
1,071 Posts
Discussion Starter #4
wont take long to do.gives 2 mpg more. less drag.
 

·
Registered
Joined
·
2,387 Posts
wont take long to do.gives 2 mpg more. less drag.
With that windshield of yours I doubt you have any problem with wind drag on any part of your bike! Good job on the bracket.
 

·
Registered
Joined
·
1,071 Posts
Discussion Starter #6 (Edited)
now if this dont mystify. i got back to the shop after dinner
and lo and behold here is rics supernice laydown bracket. i
figured my money order never got there again and just had to make
something. now i have to put his on. oh well, patience and i
never did get along. thanks ric! its even autographed.
everyone should have one.very well done and priced right.
didnt even have time to take a before pic. that is some nice thick
plastic and a perfect shaped spacer!
 
1 - 6 of 6 Posts
Top