Victory Motorcycle Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
442 Posts
Discussion Starter #1
Hey fellow wrenches.

I'm going to be swapping out rear brake lines (both the reservoir/supply and caliper/pressure lines) on my 2011 kingpin due to the conversion I have done from floorboards to vegas Ness-style pegs, in search for more cornering clearance.

I've got the vegas lines, and I have a good idea of where the lines run. Just curious to know how many hours that job has taken others that have had to entirely remove and reinstall both lines. I want to know how much time to set aside.

Thanks thumb up
 

·
Registered
Joined
·
442 Posts
Discussion Starter #2
Anyone? Kevinx?
 

·
Registered
Joined
·
403 Posts
Depends on how quick you can get the air bled out. Swapping the lines should only take 15 minutes or so, but getting them bled properly could take a while.
 

·
Registered
Joined
·
442 Posts
Discussion Starter #4
good to hear. starting the process with a mityvac to get some rbf600 in there (hardest part in my experience is getting it started if you don't have a way to suck the fluid down past the master to get the flow going). then i've got a trick little one-way check valve that allows me to bleed without a helper... cool stuff

thanks man
 
1 - 4 of 4 Posts
Top