[jtirwin27]

At the suggestions if many post here I picked up a RF 300x2 amp and a set of polk speakers. Any tips or advice for installing the amp? I bought a wiring kit and mounting bracket for the bike from Krazy cycles (general wiring kit with inline fuse). Anything specific I'll need?

 

[visionjohnny]

You should tell us what year model bike you have

 

[jtirwin27]

Valid point... 2014 Cross Country

You should tell us what year model bike you have

 

[DirtyDan]

Use an amp wiring kit, properly fused. Make or buy and amp bracket.

 

[jtirwin27]

I bought a bracket and wiring kit for my bike. It's just the general amp kit with power, ground, and remote with inline fuse.

Use an amp wiring kit, properly fused. Make or buy and amp bracket.

 

[jtirwin27]

My only question about the RF amp is can I just wire it like I have all other car amps in the past? from photos it appears to only have plugs for it. I bought mine new uninstalled on ebay from a guy who bought it but never installed or opened it.

 

[jtirwin27]

Use an amp wiring kit, properly fused. Make or buy and amp bracket.

Last question, Where the crap is everyone jumping the remote wire? Is there a standard source everyone uses? Cant seem to find my answer through searching the forum or the googles

 

[IndyVictory]

Last question, Where the crap is everyone jumping the remote wire? Is there a standard source everyone uses? Cant seem to find my answer through searching the forum or the googles

"Variable 4-6 volt hi level DC offset voltage input turn-on control"

It turns on when it sees speaker current from stereo.

I have not bought an amp yet but I am curious how your install goes. Get pics.

 

[jtirwin27]

"Variable 4-6 volt hi level DC offset voltage input turn-on control"

What language is that? I figured Id just pop a test light around to find wire getting power on ignition

 

[IndyVictory]

What language is that? I figured Id just pop a test light around to find wire getting power on ignition

You use speaker input to amp.
When amp sees voltage on speaker wires coming in it will turn itself on.

Easy peasy.

There is a range dial on side 4-6 just leave at 4.

 

[jtirwin27]

You use speaker input to amp.
When amp sees voltage on speaker wires coming in it will turn itself on.

Easy peasy.

There is a range dial on side 4-6 just leave at 4.

ahh gotcha. Thanks! I'm sure it will be very obvious once I start putting it all together