No groves instructions say to cut original grip off and sand the throttle sleeve???? I read the instruction before ordering online that they came with the throttle sleeve. I went back and reread the instructions and it only applies to the ISO grips not the ISO flame grips, sent me grips that say universal 1 inch handle bars.
I hope you have been well.
Well I am back..... nascar turns just aren't my thing.
I snapped some pictures when I was out riding on a country road for you guys to see what I am doing.
The curve/turn is posted 45mphs.
I was going back In fourth between 30 to 40mph.
I was bouncing off the...
I saw these and ordered two. It’s a “campaign” and once the orders are in, they’ll be printed on 8/3.
I’ve bought from this site in the past- no issues at that time.
these are NOT mine- came across them and they look good to me.
Figured I’d share it.
So, let me tell you what I did this week...
Ordered some Highway bars from J&P Cycles (cheaper than everywhere else, but not by much) and I was happy o get them. Tried to install then and... Well i present to you Evidence One: (hopefully the forum resizes it) Notice the top mount. Looks off...
Ok, I know this has been discussed in the past but I'm still confused...
I purchased LED turn signals to replace the rear stock signals (for now). Kuryakyn part # 2527 from Kuryakyn. The instructions state "may need load equalizer" but does not give a part number. There is no amperage info of...
Hey guys I'm sure I'm not the first to ask but I couldn't find what I'm asking.
Is anyone concerned about parts becoming less and less available or has people felt that parts have all ready became harder to source?
I'm not a Victory owner as of yet but really interested in the CC line.