Victory Motorcycle Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
Added 2 24" LED light strips to the trunk. Tapped into the trunk tail light power. Will add pics soon. Came out great for DIY.

Sent from my DROID BIONIC using Motorcycle.com Free App
 

·
Registered
Joined
·
124 Posts
A few years back I added a strip that has red in the center and amber on both ends. Wires up for turn signals, running and brake lights. I think it was 100 LED's.
 

·
Registered
Joined
·
10 Posts
:)Well I wish I could post some pictures of an LED mod I did. But I'll tell ya about it. I bought some really bright LED'S off the internet, I think they where 100,000 mcf, I drilled 4 holes in my trunk lights. And I had to buy two risestors, 10 ohm and 5 watt. This reduces the 12volts down to about 3.6 volts that are required to lights the LEDS without burning them out. I put them in parallel,all the long stems ( - ) on one side,short stem ( + ) on the other, soldered them together all the -'s on one wire , all the + 's one the other wire , ran the two wire from each side inside the upper trunk lid,down on the right side of the trunk,past the right speaker and under the seat. I then tapped into the wiring plug that has the turn lights ( don't remember the wire colors) used double sided tape on the risestors (one per side ) to the new trunk wires. The group I ride with tell me that they really show up in the day time and even brighter looking at night. I hope the that Victory will some day do this on all trunk packs, its a safety issue at least. Sorry about the long post ,I will try soon to get some pictures of it,need to get the headlight back together :mad: . Thats a real mightmare to do ,at least for me.
 
1 - 5 of 5 Posts
Top