Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Anyone done their own install of the mbw front turn signals? I was reading the instructions and it says you have to separate the forks enough to let the unit slide over it and re assemble.

How tricky is that process?

Thanks.
 

·
Moderator
Joined
·
12,984 Posts
Jack bike up slid tubes down.
remember power and ground are different on the right front blinker

next time you ask a question say what year and model your asking about
 

·
Premium Member
Joined
·
9,684 Posts
I did this job , do not rotate tubes to work them down !!! You WILL leave permanent scratches in the tubes and they will look like **** ! I cut 4 small wedges out of a 2x4 and gently tapped them into the spaces in the tree separating them just enough so the tubes would easily drop down , go just far enough so the led's slide over the top of the tubes . After this , its simplicity . As VJ said you must lift the bike off the ground . Good luck , and have a buddy there for an extra set of hands , this will help immensely .
 

·
Premium Member
Joined
·
9,684 Posts
Mobs , do it like I did ... You will not scratch them . Took me 5 min. to fab up a couple wedges ...
 
1 - 6 of 6 Posts
Top