Victory Motorcycle Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
29 Posts
Discussion Starter #1
I have an 07 hammer with Ness Ram bars that were installed by the prior owner. I like the look, but the seating position is reclined back too far for my size/comfort.
After reading some good postings here, I am about to swap out the RAM bars for either V Bars or the more current stock hammer bars. I sat on a 2012 hammer with the "regular" bars in the dealer, and it felt OK. Definitely more forward, and a hint of drag bar. I dont, however, love the look of them. Is there anyone with Victory's V bars that can measure them for me? My reference point is that if I measure the current stock bars (not my ness Ram's), it is about 13" from the center point of the bars in between their mounts, to the outside edge of the grips. that is a straight line linear measurement by running a tape from point to point. If the V bars are in that range, then I will just buy them. if they are not, well, then back to more discussions. Thanks
 
1 - 3 of 3 Posts
Top