Victory Motorcycle Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
After reading rlaws797 thread on successfully installing an OEM radio on a 8-Ball, I decided to do the same. I purchased a used radio and display from someone on here last year, and finally got around to installing it today......BUT ran into an issue. I removed the amp, replaced it with the radio module and hooked up the display to the connector labeled "DISPLAY". The display comes on and shows 'VICTORY", but nothing else. I tried disconnecting the battery (+) terminal, and then let it run for 10-15 min, but nothing. Any suggestions or did I miss something the 3 times I read rlaws797 thread ? The front and back of the fairing are still off....not sure if there is a safety switch tied into the turn signals. Someone PLEASE HELP !!!

Thanks everyone !!!
 
1 - 1 of 1 Posts
Top