Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
49 Posts
Discussion Starter #1
I have a 2011 Kingpin. Doing this oil change myself. When i took out oil plug, i did not see any washer or o ring. The Vic oil change kit has a couple of washers and one o ring. The large washer and o ring will not fit. The small washer sort of fits.
My question is, should there be a washer at all on the oil plug ?????
 

·
Registered
Joined
·
223 Posts
Use the smaller crush washer. If you look at the base of the plug there is a small bevel that will center the washer. Only toque to 15lbs this can be stripped if over tightened.
 

·
Premium Member
Joined
·
49 Posts
Discussion Starter #3
Thanks 06 for the info.
 

·
Premium Member
Joined
·
1,590 Posts

·
Moderator
Joined
·
13,185 Posts
washer is stuck to bolt or motor if there was one.
Careful on how tight you get it. It only holds oil in so don't reaf on it
 
1 - 6 of 6 Posts
Top