Victory Motorcycle Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I just picked up a 2000 V92SC, with 4500 miles. Overall bike is in great condition. Obviously the bike set more than it was rode. The fork seals will need replaced, rear tire will need replaced before the summer is up. There are a few blemishes on the paint. And I hate the exhaust, but for $4800.00 I couldn't pass up the bike. I did a quick search and could not find what years have interchangeable exhaust systems. I would be happy to pick up a stock V92C exhaust for it, just not sure what years will work for it.
 

·
Registered
Joined
·
88 Posts
You'll have to hunt for a direct fit exhaust replacement.

If you don't mind doing some fabrication (rear exhaust / muffler mount) and maybe some clearance trimming of the right side panel, just about any exhaust sold to fit the early Hammer (1st generation engine) or 92/5 Freedom engines up to '05 or so should work. (V92C to '04, Vegas [I think] to '05)

Right side peg & brake lever / master cylinder assemblies may need spacing out, as well - depends on the system you choose.
 
1 - 3 of 3 Posts
Top