Victory Motorcycle Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
1,680 Posts
Discussion Starter #1
I just bought Avon grips and was wondering if there is a way to modify the stock (08-up) Quarter-turn throttle ring to fit it, or if I have to buy the other Quarter-turn ring for it.

Thanks...


Sent from Motorcycle.com Free App
 

·
Premium Member
Joined
·
4,178 Posts
i made mine out of pvc coupler, if yours wont work you could try that
 

·
Premium Member
Joined
·
6,215 Posts
Easy to make yourself ... Paul made a good vid about it
 

Attachments

  • Like
Reactions: SubDude

·
Premium Member
Joined
·
4,178 Posts
I will look at that. I'm "barely" handy, so it might be easier to buy the right one.


Sent from Motorcycle.com Free App

its a 1" pvc coupler, cut approx 1/4" off the end, cut that to fit the throttle and glue it on. if you can install one you can make one
 

·
Registered
Joined
·
302 Posts
Since I don't have a table saw, like Paul does, I used my calipers to scribe the overall width of the ring, then scribed the mid-point. I used a mini hacksaw to cut the groove that the cables follow, then cut the ring off the coupling. I then cut the gap and fit it to the throttle.
 

·
Registered
Joined
·
1,680 Posts
Discussion Starter #9
Since I don't have a table saw, like Paul does, I used my calipers to scribe the overall width of the ring, then scribed the mid-point. I used a mini hacksaw to cut the groove that the cables follow, then cut the ring off the coupling. I then cut the gap and fit it to the throttle.

Yeah, I'm going to tinker around and see.


Sent from Motorcycle.com Free App
 
1 - 9 of 9 Posts
Top