Victory Motorcycle Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter #1
looking for the part numbers and what bushings i need to use the backrest on my 2013 cross country
 

·
Registered
Joined
·
2,699 Posts

·
Registered
Joined
·
12,296 Posts
Scooter--Is there a bearing supply in Victoria? If so, go there with the diameter and length of the bushings by measuring the places they go. Ask for thin wall nylon bushings with a split. Buy ones that are not too long and not too large - its OK they be a tad smaller - we are not talking close tolerances here. They will be far cheaper than from Vic or.....
 

·
Registered
Joined
·
2,699 Posts
Another option is to wrap the mounting posts with electrical tape.
 

·
Registered
Joined
·
291 Posts
Or find someone with a set that is willing to part with them.
 

·
Registered
Joined
·
55 Posts
Discussion Starter #6
Scooter--Is there a bearing supply in Victoria? If so, go there with the diameter and length of the bushings by measuring the places they go. Ask for thin wall nylon bushings with a split. Buy ones that are not too long and not too large - its OK they be a tad smaller - we are not talking close tolerances here. They will be far cheaper than from Vic or.....
do i need all those part numbers on a 2013 XC?

I am temporarily using tape since i got my backrest used without them.
 

·
Registered
Joined
·
55 Posts
Discussion Starter #7
anyone have pics of doing it with aftermarket bushings or know what to measure?
 

·
Registered
Joined
·
12,296 Posts
anyone have pics of doing it with aftermarket bushings or know what to measure?
See post #3. With a caliper, measure the shaft diameter and the length of the shaft and take that info to a brg shop.
 
1 - 8 of 8 Posts
Top