Victory Motorcycle Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
I want to bring my foot pegs rearwards by 2 inches or so. I found some brand new (front) footpeg mounts for my 03 Vegas (on the forum). The new mounts are from a Vegas low. Looks like the main hole centres etc are a match and a swap looks possible...

Question; the rear brake master cylinder sits around 3/4 inch further back from the original. Is there enough flexibility in the brake pipe to handle the move backwards (where the banjo bolt attaches to the master cylinder)?
 

Attachments

·
Registered
Joined
·
142 Posts
Check along the frame rail, there are clips you can loosen to allow some movement either way on both pipes.
 

·
Premium Member
Joined
·
1,571 Posts
You would most likely need to remove your MC feed line and re-attach behind down tube. The banjo may have enough room to stay where it is....maybe adjust the angle a bit.
 
1 - 3 of 3 Posts
Top