Victory Motorcycle Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I just got my rear leather fender bib made for me by Chris Wright of "Three Mutts Customs" out of Ca. Chris did a great job matching the spine on the fender and had the Victory logo embroidered perfectly in the middle of the bib. It's held down to the fender by rare earth magnets that were placed in between the leather and the felt backing, doesn't budge once placed on the fender. Not only does it look good to me but serves as a protector to the fender from my boot sliding across it. I have nerve damage from a previous bike accident that makes it difficult to swing my leg clear over the fender of a bike so this was the perfect solution. Check it
out.
.
White Automotive tire Automotive lighting Tire Motor vehicle
Automotive tire Hood Motor vehicle Helmet Automotive design
Wheel Tire Fuel tank Automotive lighting Automotive tire
 

·
Registered
2012 Victory Cross Country Tour, Indianapolis
Joined
·
3,209 Posts
I have a tank bib made by the original "Three Mutts" on my old VTX.
 
1 - 2 of 2 Posts
Top