Victory Motorcycle Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
Hi everyone , I have a 2014 CCT and was wondering what the Torque values are for the 5 bolts on the rear sprocket, and the rear axle nut? Also should I use Locktite on these NEW bolts?
 

·
Registered
Joined
·
1,099 Posts
If I read it right the sprocket bolts are 55 ft lb. The axle nut is 65 ft lb.
 

·
Registered
Joined
·
17 Posts
Discussion Starter #3
Thanks for the info, do you know if the use of Locktite is recommended , and if so which strength?
 

·
Registered
Joined
·
302 Posts
Blue. Not red. It's not in the manual, but its not going to hurt either. Me, I would do it. These bolts have backed out on a few pple.
 

·
Registered
Joined
·
1,099 Posts
Checked manual. 71 lb is what diagram says. Locktite and I was taught blue if steel into aluminum, steel to steel red. The hub bolt should be a self locking nut.
 

·
Registered
Joined
·
1,207 Posts
Correct it is 71 ft lb torqued in a star pattern. Blue loctite won't hurt.
 

·
Registered
Joined
·
1,099 Posts
+1 on the service manual. Far as I know all the X bikes are same from start to finish.
 
1 - 10 of 10 Posts
Top