Victory Motorcycle Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
I want to remove the bulky plate mount but keep the turn signals. I read a few posts on different sites that recommended cutting it off with a dremal tool. Any advice on this?
 

Attachments

·
Premium Member
Joined
·
8,711 Posts
I want to remove the bulky plate mount but keep the turn signals. I read a few posts on different sites that recommended cutting it off with a dremal tool. Any advice on this?
I cleaned mine up soon as I got the bike home.
Just place the plate as high up as possible and cut off the excess, I used a small angle grinder with a thin cutoff wheel.
Wear eye protection for bits of plastic flying.
I then removed the reflector and sectioned it till it fit in the smaller vacant spot above the plate.
Töo easy!
 

·
Premium Member
Joined
·
8,711 Posts
just be careful so you dont lose too many fingers
 

·
Premium Member
Joined
·
8,711 Posts

·
Premium Member
Joined
·
8,711 Posts
thats better...presume youll be removing the light that was above the plate too
 

·
Premium Member
Joined
·
6,019 Posts
Nice ha ha ... Good job ... I made my own LED turn signels, looks ok ... Better then the stock lollypop
 
1 - 14 of 14 Posts
Top