Victory Motorcycle Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter #1
We were installing the flip shield on the XC the other day. I had looked at the torque spec and misread it, and as a result a couple of the screw heads rounded and they are to tight. I am afraid if I don't fix it I may crack the shield. Any ideas where I can get the new hardware other than ordering it thru a dealer?? The instructions say not to use the stuff off the short shield, I think they are to short.
I know, dumb move. When I was setting the torque wrench I kinda thought 34 lbs seemed to be a "little much"
Thanks
 
1 - 1 of 1 Posts
Top