Victory Motorcycle Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
Is it possible to rotate the clutch/brake levers on the handlebars so that they are more horizontal? I feel like I have to reach down from the grips to get to them.
 

·
Registered
Joined
·
173 Posts
You certainly can, just loosen the Allen screws that hold the brake and clutch clip in place and rotate. On the clutch side be careful about location with respect to mode switch for trip computer. I would have not noticed it but read in a forum last night from another member. If you cannot rotate, then you need to clip off the alignment tab from the back where it goes into alignment hole on handlebars. It is for the factory to ease in installation and uniformity.
 

·
Registered
Joined
·
1,728 Posts
I drilled another hole into my HMD bars to relocate for my reach. I didn't want things to loosen up on the bars. The alignment hole does help to keep the controls locked in place.
 
1 - 3 of 3 Posts
Top