Victory Motorcycle Forum banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
2,675 Posts
Discussion Starter #1
I recall some time back there was a discussion of a device that could be used to facilitate fueling. It would fit in the filler neck and hold the nozzle and keep fuel from splattering. I cannot find it anywhere. Can anyone recall what it is called?
 

·
Registered
Joined
·
1,381 Posts

·
Premium Member
Joined
·
2,675 Posts
Discussion Starter #3
That's it. Thanks. Looking at it, I bet I can make one in 5 minutes a lot cheaper than $20.
 
  • Like
Reactions: CanuckRob

·
Registered
Joined
·
1,381 Posts
That's it. Thanks. Looking at it, I bet I can make one in 5 minutes a lot cheaper than $20.
yea i'm thinking the same thing.....glad i could help good luck with the design 8)
 

·
Registered
Joined
·
386 Posts
Putting a big holesaw through the obstruction at the bottom of the filler is even cheaper. Do it when the tank is empty and off the bike, blow out with compressed air to remove any chips.
 

·
Premium Member
Joined
·
2,675 Posts
Discussion Starter #6
I repainted in a matte black (Rustoleum). It does not handle gasoline spills at all.
 
  • Like
Reactions: ObiSteve
1 - 6 of 6 Posts
Top