Victory Motorcycle Forum banner

Torque Tube filter cleaning help

3K views 13 replies 5 participants last post by  TrashmanNYC 
#1 ·
Has anyone removed the filters from the torque tubes to clean them? I can't figure out how to get them off. I loosened the clamps but they won't budge. I don't wanna break anything trying to force them.

Robb
 
#4 ·
Take a set of channel locks and grab it where the filter sets on the intake. You should not have to squeeze the hell out of it. If you have ever changed out a radiator hose you have probably had this problem.
 
#6 ·
I don't know about the jackpot but on the Vegas you can get to the one on the left side. If you get it off it should open up enough room to get to the other one.
 
#12 ·
I couldn't budge it by hand, that's why I was asking. The whole intake was moving around. I stopped bc i didn't want too break anything.
 
#11 ·
loosen the clamps now spray the tubes with WD40 where the filter meets the tubes. With in a minuet they will be loose. Now twist filter with hand and pull off.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top