Victory Motorcycle Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
578 Posts
Discussion Starter #1
Could someone please tell me the size of the socket I need to remove the passenger foot peg bracket on my CR. ?

I am doing a starter replacement and I don't have a socket to fit those bolts to remove the exhaust.

Thanks.
 

·
Registered
Joined
·
123 Posts
Probably 24mm Ritchie. I say probably, because it's that on the left hand side, and the right hand side looks the same, but the socket isn't going in there unless I take the heat shield off the muffler, and its 10 o'çlock at night.
 

·
Registered
Joined
·
578 Posts
Discussion Starter #3
ObiSteve,

Thank you very much for the information and 24mm was exactly correct. You made a very long job go a lot better. I can't believe how much stuff I had to remove to get at that starter.

The new starter is in and I have started putting things back together. One twisted off bolt so I will tackle that tomorrow before I work again on re assembly.

I sure hope the new starter works and I have no exhaust leaks after all this work.
 
1 - 3 of 3 Posts
Top