Victory Motorcycle Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
Can someone please help me out. I have looked and looked at my Vision and can't seem to find a place to route the wires from under the seat down to my trailer hitch. I would like to get my bike wired so I can't start pulling my trailer and do some traveling. I have a 119190 Kit that has its own isolator. Problem is it didn't come with any instructions and which wire is for which light. Anyone ever used this product? Or could someone please give me their recommendation for a wiring harness and how they ran it down and to the trailer hitch?

My previous bike was a Yamaha Venture and all the wiring that I needed to tie into was behind the license plate and it was no problem running from there down to the hitch. But I just can't figure this Vision out. I can run it towards the front of the bike and then down and back to the hitch, but I don't see anything good to zip tie it to and I worry about the heat from the exhausts on it. Any help would be greatly appreciated.
 

·
Moderator
Joined
·
13,247 Posts
Pull your trunk and lower panels run wires behind taillights plenty of room to do it
 

·
Registered
Joined
·
38 Posts
Discussion Starter #3
Pull your trunk and lower panels run wires behind taillights plenty of room to do it
I have had the lower panels off, but I have never had the tail lights out yet. But looking up under the bike tail lights are completely encased, or so I thought, so I still don't see a way of getting the pig tail to the trailer without drilling a hole in the casing. But like I said, I haven't taken the tail lights out yet. Thanks for the advice.
 
1 - 3 of 3 Posts
Top