Victory Motorcycle Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
I'm installing mini driving lights and one of the instructions says I need to connect one of their wires to a "keyed power source" . Does anyone have a suggestion for an easily-reached wire for this purpose? I'd rather not take off the fairing but, if I have too... thanks!

Special K
Victory XC, 2012
Middle Tennessee, USA
 

·
Registered
Joined
·
2,699 Posts
Reach under the left side of the gas tank near the front. There is a 2 wire connector that is used for driving lights taped to a larger wire bundle.
 

·
Premium Member
Joined
·
6,201 Posts
Reach under the left side of the gas tank near the front. There is a 2 wire connector that is used for driving lights taped to a larger wire bundle.
Serious good info there mate.... Thumb up.

Andre
TaPaTaLk
 

·
Premium Member
Joined
·
87 Posts
Reach under the left side of the gas tank near the front. There is a 2 wire connector that is used for driving lights taped to a larger wire bundle.
Good to know. I too am thinking about driving lights on my new 2016.
 

·
Registered
Joined
·
139 Posts
Reach under the left side of the gas tank near the front. There is a 2 wire connector that is used for driving lights taped to a larger wire bundle.
Wish I would have known this when I installed my lights. I went straight to the battery. Would have liked them to be switched, but I'm not going to do over now. Just have to make sure they're off when I shut the bike off.
 

·
Registered
Joined
·
2,699 Posts
You can always put blade connectors on the wires and plug them in.
 
1 - 8 of 8 Posts
Top