Join Date: Apr 2013
Location: Peoples Republic of Massachusetts
I did this job , do not rotate tubes to work them down !!! You WILL leave permanent scratches in the tubes and they will look like shit ! I cut 4 small wedges out of a 2x4 and gently tapped them into the spaces in the tree separating them just enough so the tubes would easily drop down , go just far enough so the led's slide over the top of the tubes . After this , its simplicity . As VJ said you must lift the bike off the ground . Good luck , and have a buddy there for an extra set of hands , this will help immensely .
2014 Cross Country
2014 XC , Lloyds A/F , Timing Wheel +4 , PCV , Miller Mufflers , 1/4 Turn Throttle Ring , Dyno Tuned by KMC Powersports 98HP 113 TQ